The
BLINDER M-10 TWIN should be mounted facing the front or back of
the vehicle. The M-10 TWIN should be mounted between the passenger
side headlight (or taillight) and the driver's side headlight (or
taillight). The on/off button and the beeper are of course placed
inside the cabin of the car.
|
|
| Mounting |
|
 |
| Divide
the front of the car in two half's. Install one of the BLINDERs
M-10 in the middle of one half, and then do the same on the other
half.
The distance between the two units must be 50 - 60 cm.
BLINDER performs equally well when mounted horizontally or
vertically with the lens in the forward direction. Please click
here for Specification Sheet.
|
|
The two BLINDER units fits into the front of most cars.
Here on the Dodge Neon used at the Texas Field
Test.
|
| Horizontally
and vertically |
|
|
|
It is very important, that you mount the two
BLINDER M-10's very carefully. The two units must point straight
ahead. Otherwise the detectors and jammers will not function
optimally.
Avoid positioning anything in front of, or
obstruction the lens. The lens must project from, or lie flush
with the grille. |
|
The two units must point straight ahead. That means
horizontally
to the road surface and parallel to the driving direction.
|
The
Self Test Function |
|
|
|
When
the ignition is turned on, the upstart self-test function will
turn-on the in-carbine alert for two seconds telling you that the
BLINDER is ready to do its job.
|
| Electrical
Wiring |
|
|
|
|
| Service
and control |
|
|
|
Keep
in mind that snow and dirt that gets on the lens decreases the
output of the BLINDER M-10 TWIN's range to where it may not detect
or jam the police laser gun when you need it. Keep the lens clean
and as free of debris as possible. Scratches and stone damage can
also affect output. If the lens becomes too badly dam-aged, order
replacement lenses separately.
|
| Don't
drive illegally |
|
|
|
We
recommend against driving recklessly or above the posted speed
limit and assume no responsibility for the actions of any person
that purchases or uses the BLINDER M-10 TWIN. We cannot replace
your driving license, so drive legally, responsibly and carefully.
|
| How
to use your new BLINDER
|
|
|
|
| For
avoiding any trouble with the police, we strongly recommend to
follow the method mentioned below when dealing with police laser
guns:
At the moment when you hear the BLINDER warning signal, you
must at once
- Slow down if you are speeding
- Switch off the BLINDER
In that way you will allow the police to get a clear speed
measurement without making any attention. Sometimes the police
need two or three shoots before getting a usable speed
measurement.
Therefore turn off the BLINDER within a few seconds,
and nobody will suspect that something is wrong!
|
| Online
service |
|
|
|
If
you have any problems or questions regarding the installation of
your BLINDER, please contact us at sales@blinder.dk.
|
| BLINDER
M-10 Specifications |
|
